Tractor Talk Discussion Board |
Re: Tire air pressure
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by JoeBob/IN on March 05, 2007 at 13:23:13 from (216.117.22.1):
In Reply to: Tire air pressure posted by IaGary on March 05, 2007 at 04:38:45:
I assume this is in reply to my post so I will try to prove why I said what I did. The link is from the Firestone site. Lets use my Case 2390 for an example. It weighs roughly 14000 lbs with the weights on her. And I guess that it is balanced to about 40/60% front/rear. Could be off there but close enough for now. So 60% of the 14,000 is 8400 lbs on the rear axle and 4200 per tire. It has 20.8R38's so according to the chart I should run at 8 psi since you can load a max of 4300 per tire at 8 psi. Even if it is balanced to 30/70 we would run at about 11 psi. But I run duals so according to Firestone we have to drop our max axle loads 12% per tire. At the 30/70 the per tire load is 2450 + 12% so we get a max load of 2744 and our psi would be as low as 6! Now there are cases where you would add pressure such as high road speeds, furrow plowing, and hillsides to increase stability. Remember that you have to add the weight of any attached equipment but not drawn equipment. And you shouldn't load radial tires but rather add cast weight, it doesn't allow the tire to flex properly! Look at the Firestone, Goodyear, and Michelin site carefully and you will see that radials are great tires when used correctly.
Replies:
Home
| Forums
Today's Featured Article -
Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
Nice Marvel Schebler DLTX 8 bronze body carburetor For 1934-1936 unstyled A tractor.Serial No.410000-42850. All restored and ready to use.
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|