Tractor Talk Discussion Board |
Re: Adjusting a voltage regulator
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Glen in TX on March 11, 2007 at 13:47:09 from (208.246.9.227):
In Reply to: Adjusting a voltage regulator posted by Pete76NY on March 11, 2007 at 11:38:59:
This applies to most Delco regulators with 3 terminals but may vary for others. You can clean the regulator points some but use something very smooth and not coarse grit paper and don't file off too much just clean them. Points gap for most regulators is about .020". Usually with the 3 regulator terminals on outside facing you the coil on left is the cut out relay. It is adjusted to where it closes at 6.4V or 12.8V with 12V system. The coil on RH side has a screw behind it and is adjusted for voltage usually CW to increase or CCW to decrease for about 6.9V or 14V with 12V system. The armature air gap on that coil should be about .075" holding gap closed while adjusting screws. As said if battery is bad or not up to full charge or wiring bad or you didn't polarize system after connections were made before starting all this is usless and there were many different regulators so this is an example only and settings may not apply to all. If has a relay instead of a true regulator you will have to adjust one of the generator brushes to increase charging some. That has been covered hundreds of times on here in posts and in YT stories and tips.
Replies:
Home
| Forums
Today's Featured Article -
Show Coverage: Godfrey, Illinois Country Days - by Cindy Ladage. Except for last fourth of July's Old Gold show in Springfield, Illinois, I don't remember when it was so hot. Nevertheless, the heat didn't keep vendors and visitors alike from enjoying the third annual Country Day's Event. Jane Elliott said the event was originally a one man show. "Barry Seiler, owner of Country Town Farm Supply store used to invite people up to the Johne Deere store. He would give hats and a free meal for everyone that brings a tractor." Elliott said while this
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|