|
Tractor Talk Discussion Board |
Re: ferguson 20 or 30
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Pajamafied John on March 18, 2007 at 13:01:48 from (68.55.81.179):
In Reply to: ferguson 20 or 30 posted by marvin on March 18, 2007 at 12:50:16:
If the oil filter is located inside the oil pan it is a TO-20. The TO-20 oil pan will have a circular plate and gasket on the bottom that is bolted in the center. Not the best design in the world but well....Also, as I recall the TO-20 engine will have a casting on the block starting with Z-120. The TO-30 will have Z-129. I have a TO-20 that has been a wonderful little tool. Tough little critter. Enjoy it
Replies:
Home
| Forums
Today's Featured Article -
Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
18-32 Case Cross Motor
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
