|
Tractor Talk Discussion Board |
Re: Generator/voltage regulator problems.
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by souNdguy on March 28, 2007 at 08:05:26 from (12.65.60.33):
In Reply to: Generator/voltage regulator problems. posted by MBU on March 27, 2007 at 21:57:46:
i got a question.. you said it was a 3 brush job.. 3rd brush gennies usually have a cutout realy only.. and have an adjustable brush holder on the back of hte genny.. the 2 brush gennies have the vr.. so which you got? is it a circuit or b circuit? never mind.. I'm guessing worn brushes or tall mica.. pull it down and see if the mica needs to be undercut ( hacksaw balde.. ) Soundguy
Replies:
Home
| Forums
Today's Featured Article -
The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
18-32 Case Cross Motor
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
