Tractor Talk Discussion Board |
Re: John deere flywheel help
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Maark on March 31, 2007 at 09:50:28 from (206.72.3.156):
In Reply to: John deere flywheel help posted by two cylinders saves gas on March 31, 2007 at 09:25:06:
Remove the outside cover, there wil be 2 bolts visible, and a large pressed tin nut. Remove the pressed tin nut and loosen the two large bolts. Be sure the flywheel and crankshaft are marked so that you can reinstall it in the right position. you may need to drive a chisel in the space between the slots on the flywheel. It should pull off by hand. Be careful they tend to be heavy. You will need a B130R cork seal or if it used a rubber D-ring seal use a B3028R. The seal is located inside of the flywheel spacer.
Replies:
Home
| Forums
Today's Featured Article -
Product Review: Lead Substitutes - by Mike Schordine. Lead was oriinally added to gasoline as an upper cylinder lubricant. It lubes the valves and seats. If you rebuild the motor, you could use hardened seats and valves, and unleaded fuel. But if your old tractor runs good, a simple lead substitute added to the gas is a perfectly reasonable solution. And, if you are like me, your tractor is under cover, but it sits outside. So with every temperature change, the humidity in the air collects in the fuel tank, in the form of water.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|