Tractor Talk Discussion Board |
Re: Help A Dummy?
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by PatMz on April 12, 2007 at 15:46:02 from (4.228.117.140):
In Reply to: Help A Dummy? posted by Allan In NE on April 12, 2007 at 13:50:45:
In the time it'll take you to drill those holes (I'm assuming these are the plates for the F11 like you showed me a couple months ago) you could almost drive to Sydney, North Platte, Cheyenne or Denver and have them fabricated! Mine were only $26 at DenCol Iron, about the same as good bits, ready the same day I faxed the dimensions. You might could get by with cheaper bits, real slow and with lots of oil.......... 1/16 over is standard, I went with 5/8 and hand reaming to minimize slip. You got a drill press? Drilling freehand will test your mettle (pun intended).
Replies:
Home
| Forums
Today's Featured Article -
Museum Coverage: The Stuttgart Agricultural Museum - by Cindy Ladage. While cold wind was blowing back in Illinois, in Arkansas, daffodils were in bloom, and the Magnolia trees were adorned with fragrant blossoms. Stuttgart, Arkansas was the site of this year's winter Minneapolis Moline Collector's show February 25-27, 1999. The show was held at the Oliver Museum created by Don Oliver, the pioneer of the four wheel drive tractor. Oliver along with Gale Stroh and Kenneth Bull using Minneapolis Moline tractors and parts created what has become known as
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|