Tractor Talk Discussion Board |
Re: Since jlmtractor asked a basic question...
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by georgeky on April 19, 2007 at 13:58:32 from (152.163.100.14):
In Reply to: Since jlmtractor asked a basic question... posted by Mike CA on April 19, 2007 at 13:21:40:
Mike Plowing is the first step, this turns in organic matter left by crop residue and loosens the soil so the disk will work properly. Then the disk works the ground fine enough to plant crops in, they don't do well in clods. I suppose the contraption you refer to is a middle buster, not everyone uses those. It puts the crop on a ridge for drainage or moisture purposes I guess, we don't use them in Ky. The purpose of cultivating is for weed control and loosening ground so it can absorb more moiture. If ground is packed tight heavy rains tend to run off insead of soaking in. Tobacco in particular will not start growing good until it is cultivated and the next day you can tell a big difference in it. I am not good at explaining some things, I hope this clears it up a little
Replies:
Home
| Forums
Today's Featured Article -
Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
18-32 Case Cross Motor
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|