Tractor Talk Discussion Board |
Re: building block wall
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Billy NY on April 27, 2007 at 12:41:51 from (64.12.116.14):
In Reply to: Re: building block wall posted by Bryan in Iowa on April 27, 2007 at 10:29:20:
Preferrably outside of wall, use corrugated/ perforated foundation drainpipe, on top of footing where footing meets the wall. Pipe is covered with coarse stone, like #2 crushed, place filter fabric over the top of stone to keep fines from settling in and choking up the voids. Footing will be level, but if you can set the foundation drain pipe on a slight pitch to one end that is low, that is ok, think most are set level. You then use a Tee to send out a lateral to where you want it to drain. The foundation drain loop will fill and drain to the lateral which would be set at the lowest elevation for good drainage. You can use coarse stone to bed one side a little higher for pitch but even if level, as long as it's got a place to run to, should be fine to divert the water out. If you are boxed in, you could run the lateral to a sump pit in the basement, use a sump pump, but preferrably, you want that pipe (solid for lateral, not perforated) to penetrate the walls and drain by gravity away from the building to a drywell or daylight to where it can run off. Plan this out and put sleeves where you want to drain to, so you can run a pipe through, wall or footing if necessary so you don't have to chop it out later.
Replies:
Home
| Forums
Today's Featured Article -
Box Plow Blues - by Tom Schwarz. One of the first implements most tractor owners obtain is the box plow. For very little money, this piece of equipment promises to plow and flatten any hill or vale on your ranch road or farm. At least that's what I thought! As simple as a box plow appears, it can be rather challenging to make work correctly. In our sandy soils of Florida, traction is king. You can never have wide enough tires or heavy enough weights to get all the traction you want … unless you own a monster tractor. U
... [Read Article]
Latest Ad:
18-32 Case Cross Motor
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|