Tractor Talk Discussion Board |
Re: O.T. 15 H.P. Briggs Stratton Question
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by farmall100 on April 30, 2007 at 19:58:11 from (66.207.230.102):
In Reply to: O.T. 15 H.P. Briggs Stratton Question posted by genos on April 30, 2007 at 19:42:59:
I know you said you've checked the oil level, but I'm going to through this out for discussion anyway. Some B&S engines with gravity feed gas tanks will continue to drip gas thru the carb due to a sticky needle valve (I don't know if this is the correct terminolgy but bear with me) this happens when the engine is not running, the carb fills with gas and the gas overflows into the crankcase causing the oil level to increase and this mixture is sucked up and burned causing a smoke screen. I had this happen with a DR mower with 10hp B&S engine. the cure was to install a cutoff valve below the gas tank
Replies:
Home
| Forums
Today's Featured Article -
Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
18-32 Case Cross Motor
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|