Tractor Talk Discussion Board |
Re: Rescued VAC-Stuck Ring?
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by RAB on May 01, 2007 at 23:25:03 from (195.93.21.42):
In Reply to: Rescued VAC-Stuck Ring? posted by JRT on May 01, 2007 at 20:20:40:
JRT, You wrote: I think maybe the ring is stuck I ask: how much is no compression? Have you carried out a compression test - both dry and wet? Until you do we have litle in the way of hard facts to go on. If there is no compression at all it could be a hole in the piston. It should not sound too good either. All these things are very subjective - no hard facts/information, so you need to find out as much as you can before deciding on the most likely route for repair. Personally, as it will have about 4 rings on each piston I doubt you have seen inside an engine? (as you say "the ring is"). No problem - everyone has to start somewhere, but understanding the basics is easily found in a book. When an engine sits an exhaust valve will always be open and like as not this may not be sealing correctly after several years. It may be sticking or the head/seat rusted (we don"t know the conditions it has been in for the last several years). It may have a broken valve spring, a burn"t valve (from before it sat), a sticking stem stopping it closing properly, a cam lobe worn out (so too little valve lift), a broken or otherwise valve rocker. The inlet valve may have been open as well and that too may have problems ( a cylinder with just an inlet valve open is usually protected by the oil bath aircleaner). So upshot of all this is that is is useless soaking it in anything if the fault is a chipped valve or similar, so investigate a little further first. Hope this helps. Regards, RAB
Replies:
Home
| Forums
Today's Featured Article -
Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
18-32 Case Cross Motor
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|