Tractor Talk Discussion Board |
Re: Ford 600 stalls when hot
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Gerald J. on May 10, 2007 at 10:32:37 from (67.0.103.136):
In Reply to: Ford 600 stalls when hot posted by Lester Thomas on May 10, 2007 at 09:48:48:
Could be coil, could be condenser, could be carburetor, fuel line, fuel filter or a screen in the carburetor inlet fitting or the tank outlet. It would be plugged gas tank vent (often the cap, a modern car cap doesn't vent) but it should idle longer if its the gas tank vent. Could be some of all of the above. Your task is to find which without replacing the tractor. There are some things you need to do when its still running but about to stop. You need to observe whether it quits abruptly or sputters first. Then if it sputters you need to see if adding choke will make it run better momentarily. If the choke helps for a bit, its starving for fuel. If it stops apruptly its more likely ignition. Coils heat for ten minutes and short a turn which kills the spark. Then you check for spark. I just pull the center wire from the distributor. Good spark should jump more than a quarter inch that wire end is held near the block and that spark should be blue. Yellow and skinny isn't good, probably shows a bad condenser. No spark at all hints at stuck points or a bad coil. If its fuel starvation there's restriction to flow in the fuel system. There's probably a drain plug in the bottom of the carburetor. With that pulled and the valve open at the tank there should be a pencil sized stream of fuel for as long as you test (until you run the gas tank dry). No slowing. Then if its slow or stops you take the lines off until you find a good flow and fix the problems. There is often a screen attached to the inside of the fuel line adapter at the carburetor inlet that is prone to clogging with dirt and varnish. It will stop a tractor and your Ford is old enough for that. Gerald J.
Replies:
Home
| Forums
Today's Featured Article -
Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
18-32 Case Cross Motor
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|