Tractor Talk Discussion Board |
Re: OT-wheel chair ramp slope?
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Hal/WA on May 29, 2007 at 23:26:37 from (66.45.175.118):
In Reply to: Re: OT-wheel chair ramp slope? posted by Walt Davies on May 29, 2007 at 10:03:09:
I agree. I put a ramp to our front door when my wife was going to have knee replacement. I only had so much room to make it work, and in practice, it is a little steep. A heck of a lot better than no ramp at all, but kind of scary for a wheelchair bound person to go down alone and really hard for them to make it up on their own. But with someone pushing up or holding back going down it is just fine. My ramp is only about 4' wide, and that has never been any problem at all. Again, I built it to fit the space I already had. Good luck!
Replies:
Home
| Forums
Today's Featured Article -
A Brief History of Tractors in Australia - by Bob Kavanagh. After Captain Cook's exploration of the east coast in 1770 the British Government decided to establish a penal colony in Australia. The first fleet arrived in 1788 and consisted mainly of convicts who were poorly equipped and new little of farming techniques. The colony remained far from self-supporting and it was not until the early 1800's that things started to improve. Free settlers started to arrive, they followed the explorers across the mountains and where land was suitable set up farms. T
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|