Tractor Talk Discussion Board |
Re: Now its up to mother nature.
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Rich Va on May 30, 2007 at 17:57:44 from (65.40.109.22):
In Reply to: Re: Now its up to mother nature. posted by IaGary on May 30, 2007 at 16:36:53:
Gary that's why I asked,long time ago and up until only a few years ago John Blue was the only nitrogen rig in this area. They had a ground drive pump for the trailer type and a sprocket on the tractor wheel if it was mounted.They were very accurate,you could almost measure land with it. Back in the 50s people were useing 37%N on the corn,had to knife it in,30% for the wheat and just dribble that on,and then the flat fan nozzles came along and we used those for the corn and the wheat. Now everybodys back knifing 30% in corn useing pto pumps. I got to quit thinking about the past.
Replies:
Home
| Forums
Today's Featured Article -
Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
18-32 Case Cross Motor
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|