Tractor Talk Discussion Board |
Re: OT - Does anyone know how to tap a water spring?
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Billy NY on June 25, 2007 at 20:20:03 from (205.188.117.71):
In Reply to: OT - Does anyone know how to tap a water spring? posted by Todd in SE Ohio on June 25, 2007 at 14:30:47:
We had a water problem at our place where the horses are, knowing the water table and or springs in the shale, was not that deep, due to the geological structure under the ground, we set a round pre-cast concrete basin, I'd have to look at the photos, but I think it was 3 sections deep, 2 were perforated, like a drywell, the bottom solid, I wrapped the perforated sections with filter fabric, then backfilled with crushed stone, clean potable water drains into the bottom section, where I have a screened inlet, I ran black polyethylene water pipe to the barn a few hundred feet away, where the pump is, and it's worked great for a reliable water source. The were pumping out of the pond before that, not so good water.
Replies:
Home
| Forums
Today's Featured Article -
The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
Latest Ad:
18-32 Case Cross Motor
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|