Posted by Jerry/MT on September 07, 2007 at 21:29:05 from (206.183.116.129):
In Reply to: Rock removal ? posted by MNBob on September 07, 2007 at 06:55:47:
I live in the Mission Valley of Western Montana and it used to be part of glacial Lame Missoula. We have boulders the size of Volkswagens on our place. Before I bought I read the soil reports that siad 85-90% of the rocks were 3.5 to 4.5 inches. I wish that was true. I think 10-15% are 3.5 -4.5 inches and the rest are bigger. When I broke the ground for my wife's garden, part wat through plowing I noticed that I had to apply more throttle to the tractor to plow at the same speed. I lifted the plow to investigate and a triangular portion about 1.5 inches on a side was missing from the point of the share. It probably struck a boulder and broke off. I finished the plowing with the broken share. They don't make replacement shares for the old Detroit plow I was using. Since I'm a rancher( that's a guy who never plows anymore ground then his wife can take of) it's just as well.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
