Posted by KEH on September 10, 2007 at 04:56:08 from (209.213.31.99):
In Reply to: Re: clipping pasture posted by j 105 on September 09, 2007 at 19:52:46:
You may be right about different soil types or possibly some different variety. I wonder if the cows refuse to eat it if they are on it from the first of the growing season in the Spring?
When had Sericea for hay it was necessary to cut it when it was about knee high. If it gets much taller, the stems get too tough and large to make good hay. Cows will pick through the hay and eat only the tender tops. I would get two cuttings a year here.
To cut for hay, the problem is leaf loss. If it gets too dry, the leaves shatter off. Cut about an hour, check the very tip of the stem. When the leaves at the top are dry and crispy it's ready to bale. Bales will be heavy and seem too green, but they will cure out and keep fine. Cows like the hay. Don't know about horses, but years ago a relative sold sericea hay on order to a horse owner who had definite ideas about how it was to be baled.
This time of year the sericea is too big to cut for hay. Don't think its a good time to spray it. Spraying with 2,4d probably works better in the Spring when it is young and tender. If you have problem spots in your fields and it is feasible to do so, I would clip it before it makes seed. My opinion based only on reading about it is that nothing beats native grasses for grazing on the Great Plains and that other invasive species are bad.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
Nice Marvel Schebler DLTX 8 bronze body carburetor For 1934-1936 unstyled A tractor.Serial No.410000-42850. All restored and ready to use.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
