Posted by Dave_Id on September 14, 2007 at 08:36:18 from (70.112.233.145):
In Reply to: OT: building a flue posted by mark on September 14, 2007 at 08:11:34:
You can save yourself a whole lot of labor by installing triple wall, or perhaps just a double wall pipe sold at your local Home Depot. I've built 3 chimneys in my younger days. You need to start with a good foundation, or I built one right on the garage floor. Start with the square chimney blocks, and your lowest one will need a cleanout installed. The flupipe (I used the square 8 inch tile pipe) will sit and cemented right to the floor. Just built straight up from there. Knock a hole in the flu pipe where the pipe from the stove goes thru. I think, if I remember right, they sell a square block with a hole already in it to install the sleeve. Don't worry about the connection from sleeve to the flue pipe. Knock off the mortar on the inside of the flue, so it'll be relatively smooth. When you get as high as you want to go, take mortar and taper up to the flue pipe so rain water can run off. If the chimney is inside the house, you may want to install a rain cap, or water many end up in your basement. I may have missed a few things, it ain't hard, but it'll take a good day to build with one person helping to mix mortar, hand you the materials, and help drink beer.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The 8N and the Fox - by Zane Sherman. Dec. 13 1998, Renfroe, Alabama. Last niht I dreamed about the day that I plowed the field of about 10 acres over on what Jimmy and Dandy called the Ledbetter field. I was driving the 1948 8N Ford tractor that Jimmy bought in 48 new This was prebably in about 1951 and maybe even befor the house was built. This would have made me to be about16 years old and I drove the tractor for nothing and would have paid to drive it if I had had any money which I didn't, but neit
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.