Posted by Bob on September 20, 2007 at 20:37:28 from (69.178.229.154):
In Reply to: ford draft control posted by jeffkrause78 on September 20, 2007 at 20:28:36:
The main farming operation draft control is used for is moldboard plowing.
Postion control lowers the plow to a fixed, pre-set depth, and leaves it there.
Draft control responds to the increased draft of the plow while going through a "tough spot", and raises the plow, putting increased downward pressure on the rear tires while raising the plow, which helps with traction if the tractor is beginning to "spin out", and the "draft" is now lessened, because the plow is not in the ground as deep.
As the plow passes the "tough spot", and draft decreases, the draft control drops the plow back to the original depth.
You don't mention a specific tractor... some have a 2-position lever, and you have to choose either "depth control" or "draft control". Some tractors have a lever that allows for infinite adjustment between full draft control and full position control, or a mix of the two.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
