I don't think the NH boom will give you any trouble. I have an LS170 and it's been hammered about as hard as anything can be hammered. In 3000 hours the problems I've had to date include the bottoms of the final drive cases wearing thin at the back and leaking, and generally wearing bolt heads off the bottom since it's in the mud a lot and dragging. I've also had to replace the parking brake/pinion shaft and motor shaft in the reduction case along with doing the drive chains while I was in there. I'm not quite sure why but the bolt that retains the pinion shaft to the motor shaft came loose. If I had caught it first when it was rattling around the chain case it would have been a simple matter of replacing the bolt.... but I thought the noise was a rock between the wheel and the frame... so it ended up wearing the splines out from working loose. Small repair that got to be a large repair... Wheel bearing kits are the other gremlin with this one. Again, it's in mud and doesn't get greased as often as they should since I've got to pull the wheels to grease the wheel bearings. Otherwise, hydraulically and enginewise it's been an excellent machine. THere's a few little design things that NH could have done to address the shortcomings that I've had with it, but I wouldn't hesitate to buy another all the same. From what I've seen of the competition that spends it's life standing on it's back door, or face planted with the loader in the air.... I'll stick to the super boom and deal with the litle things.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - An Old-Time Tractor Demonstration - by Kim Pratt. Sam was born in rural Kansas in 1926. His dad was a hard-working farmer and the children worked hard everyday to help ends meet. In the rural area he grew up in, the highlight of the week was Saturday when many people took a break from their work to go to town. It was on one such Saturday in the early 1940's when Sam was 16 years old that he ended up in Dennison, Kansas to watch a demonstration of a new tractor being put on by a local dealer. It was an Allis-Chalmers tractor dealership,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.