Posted by chrisjensen on November 06, 2007 at 21:19:38 from (64.119.2.18):
Has anybody changed the originial hydraulic lift piston on a 1948 TE 20 Ferguson which had three steel rings for sealing with a newer style piston which uses a rubber o ring and a leather sealing washer? I've been told that the newer style piston which has the same dimensions as the originial piston does a better job of sealing. the new piston I have is for a Ford NAA. I ordered the piston, o ring,and sealing washer from Yesterday's Tractors . I've ordered a new cylinder as there was a lot of leakage at the hydraulic cylinder end with the hydraulics raised and my bush hog attached to the 3 point. It is my opinion that a rubber o ring would be better at sealing than the steel rings.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
