Posted by cat236 on November 29, 2007 at 21:53:57 from (64.136.49.229):
In Reply to: Got A Minute? posted by Allan In NE on November 29, 2007 at 08:17:56:
Seems to me the loader is the trick,yes a little shakey with single acting cylinders.The way I see it raise the loader to full height,cut two lengths of angle iron to lay on cylinder rods,this locks both sides fixed, now you have a stationary point to use your chain hoist as earlier suggested.Postion tractor and power unit behind the Gleaner hook up sling and raise with chain hoist.Now with a second tractor pull Gleaner in under hanging power unit.Trying to position hanging weight gets so risky,I have done plenty of it.Any time you can raise load and not have to "move it" the better. I have even done this when unloading extra heavy freight off of freight carriers.I lift, they pull forward, then I set down to gain more control.This way also would allow you to be on the machine to position engine as you lower into place. I wish you well, after viewing all of your posts over the last several years I am certain you were the origination of "If there is a will there is a way!
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
