Posted by Glenn FitzGerald on December 10, 2007 at 20:31:52 from (64.109.36.44):
My brother has a 26' IH model #45 field cultivator (I think that's the proper name for it). It has a wing on either side which fold up for transport. (The hydraulic transport system works just fine.) It is set up with two master hydraulic cylinders on the center section and one slave cylinder on each wing. The problem he has is the wings will not fully drop. The center will be at the desired depth and one or both wings will still be up out of the ground or only partially in the ground. One side is worse than the other, but neither side works properly. If a person holds the hydraulic lever back on the tractor and lets it "growl" a while, the wings usually drop more, but still not enough.
Apparently there is air in the lines, but it seems no amount of bleeding will correct the problem. Uaually after a time consuming effort to bleed out the air, the wings drop better, (still not right) for a while, but after a few series of up and downs, the problem is back, as bad as ever.
We have two neighbors who had similar models with the same problem. At times they worked at it so long, they had pumped five gallons of oil on the ground and still the problem persisted. Finally they each traded off their machines.
Is there some trick we are missing? We did not buy the machine new, but near as we can tell the entire system is as it was from the factory.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Uncle Cecil's Super A Lives Again - by Mike Purcell. A week or so out of most of my childhood summers was often spent with my Uncle Cecil and Aunt Sissie in the small East Texas town of Maydelle on their 80 acre farm. Some of my fondest memories of these visits are those of learning to drive a tractor at the helm of Uncle Cecil’s 1948 Farmall Super A. Uncle Cecil was the second owner of this wonderful little tractor, but it was almost as though he had adopted an infant. The original owner was a man from Minnesota who bought her from a local dea
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
