Once you find the cause, see if you can stop it from repeating the cycle as already said.
One tool that takes the work out of the chopping by hand and I assume there is dirt under your location (no concrete, pavement or utilities) etc., is a chipping gun as I call it either a small, medium and or large electric jackhammer, will work fine, and if you have nothing under it to worry about and you can get power to the location, one of these makes short work of clearing thick ice, frosted and heaved areas under door ways etc., I use an old bosch, similar in size to the brute they make now, I've hacked through some 2-3 feet of ice build up around the barns, built up from ice/snow coming off the roof, they're meant for breaking concrete, ice is a lot easier. A heavier one will be more of a work out, but like I mentioned, the hammer bit breaks that ice up easily, I prefer a flat end, the point may send chunks up to your face, use safety goggles and hearing protection if you use one.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Usin Your Implements: Bucket Loader - by Curtis Von Fange. Introduction: Dad was raised during the depression years of the thirties. As a kid he worked part time on a farm in Kansas doing many of the manual chores. Some of the more successful farmers of that day had a new time saving device called a tractor. It increased the farm productivity and, in general, made life easier because more work could be done with this 'mechanical beast'. My dad dreamed that some day he would have his own tractor with every implement he could get. When he rea
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.