Posted by Don-Wi on January 05, 2008 at 16:24:38 from (99.165.179.236):
In Reply to: OOOPPPPSSSSS posted by Ken Faust on January 05, 2008 at 12:44:46:
Sounds like ya found the dipstick then? If not it's at your right heel, in the plate that's bolted to the side of the transmission. You might be able to take off the plate on the bottom of the bellhousing and spray some brake cleaner up in there, but as the others say an oiled clutch disk isn't good and probably should be replaced.
My brother and I pulled the engine outta his 550 today to put in the new crankshaft, and found that his clutch disc is well oiled as well. Not sure where it's coming from yet, but we'll be sure to find out before reassembly.
Donovan from Wisconsin
FYI: I think the transmission should hold somewhere around 8-9 gallons. That's about what out 165 holds and it should be similar in size to that. Not sure what out 285 holds, but I'm sure its a couple more gallons.
Also, make sure it's a hydraulic/transmission fluid, not just hydraulic oil. Massey's aren't as fussy as some other makes, but I've heard plenty of guys say that the massey's just don't seem quite right when using anything other than MF's Perma-Tran III fluid in their multi-power tractors. We've never used anything but, so I can't say. We use the same oil in our Oliver's hydraulic systems as well, just for convenience sake.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
