Posted by Jim in NY on January 11, 2008 at 18:32:00 from (206.15.129.220):
In Reply to: ??????? posted by Sawyer on January 11, 2008 at 10:25:56:
There are alot of fixes for this problem " if " the rings can hold up to the breakaway thrust that happens when and " if " one is lucky enough to even get the crank to move without breaking rings, ect.
My thoughts on this are the rubbing alcohol or auto trans (or mixture of both), also deisel fuel has alot of Hydrogen energy releases when heated (expansion) along with some internal heat... best way to accompish this is to get one of the Katz type heaters that go into the lower radiator hose and isolate it from heating up the entire radiator by blocking off the upper hose and the "upward side of the heater at the installation point -- that way you are only heating what is in the block and around each cylinder. Let it do it's heating for some time, perhaps a week or two" then gently nudge the crank with a bar a little at a time until anf " if " you get lucky. It's amazing what a little heat at operating or above temperatures can do. Good Luck.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Product Review: Lead Substitutes - by Mike Schordine. Lead was oriinally added to gasoline as an upper cylinder lubricant. It lubes the valves and seats. If you rebuild the motor, you could use hardened seats and valves, and unleaded fuel. But if your old tractor runs good, a simple lead substitute added to the gas is a perfectly reasonable solution. And, if you are like me, your tractor is under cover, but it sits outside. So with every temperature change, the humidity in the air collects in the fuel tank, in the form of water.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.