|
Tractor Talk Discussion Board |
Re: Plastic gauge
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Steve Crum on June 04, 2007 at 05:35:39 from (4.156.231.240):
In Reply to: Plastic gauge posted by MTJC on June 04, 2007 at 05:11:39:
These are a very simple test strip. the material itself is like a stick of spagetti and comes in a tear off package. Take off the rod cap you want to check and thoroughly clean the crank journal and rod bearing then wipe a very thin film of oil on the rod bearing with your finger tip. Cut off a piece of the plastigage package the length of the first test being careful not to distort the gage strip inside. Pull the piece of gage strip (about and inch long) out of the package piece you just cut off and carefully place it across the journal. put the rod cap back on and torque it to spec. Be very careful not to move or turn the crank while the gage in in place. Now remove the rod cap and you'll notice the gage media is squashed on the journal. Use the piece of the package you cut off that you notice has bars printed on it of various widths and above each one a numerical referance in thousands of an inch and or millimeters, hold the edge down to the squashed media on the crank journal and find the bar that is closest in width to the squashed media, the numerical referance number is the actual clearance between the rod bearing and the journal. Always do this test at the center of the cap and not at the sides by the bolts. And clean the media back off the journal before wrapping up.
Replies:
Home
| Forums
Today's Featured Article -
Uncle Cecil's Super A Lives Again - by Mike Purcell. A week or so out of most of my childhood summers was often spent with my Uncle Cecil and Aunt Sissie in the small East Texas town of Maydelle on their 80 acre farm. Some of my fondest memories of these visits are those of learning to drive a tractor at the helm of Uncle Cecil’s 1948 Farmall Super A. Uncle Cecil was the second owner of this wonderful little tractor, but it was almost as though he had adopted an infant. The original owner was a man from Minnesota who bought her from a local dea
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
