I think a lot depends on your soil conditions. 1st thoought is dealing with the sod/root bound soil, it's going to peel up when you use something with a cutting edge on it, might be best to use some tillage equipment or similar first, break it up, and so you don't waste top soil with the clumps. With a dozer I would strip the top soil, stockpile, do the grade work and replace the topsoil again, problem is that the sod will peel up and you still need to break it up to be able to spread it back out again and grade it off. Strip the top in the fall, stockpile, let it sit all winter, rot all that organic matter, shift it again with the dozer untile it's loose, then spread back out again. Might want to consider some erosion control, silt fence stakes and hay bales etc.
If you have reasonably small cuts and fills, you could do it with that tractor and a box blade, but not while it's in sod. If those cuts and fills are substantial, might be easier to strip the top in the affected areas and import some good clean natural fill material, lot easier to work with and grade than lumpy sod root bound clumps, then let the top soil rot a little like mentioned above.
You could make a mess both with and without a dozer, one of our fields is like that, but the hills are shale, they are not worth fooling with. My food plot was really unlevel, I turned it, disc'd a few times, then took all the sod clumps and put em in the low areas, used the front end loader like a dozer and shaved a little here and there, not perfect but much better, little more work and it will drain off, no more soft areas with trapped water.
I'm not sure how a tiller handles on one of those 860's, if you just want to skim here and there, you have to loosen up the sod layer, and use some care in thinking about what you are doing, strip to much top in one area and nothing good will grow, that is what happens here when you take off the top, it's like the next layer is almost inert.
Sometimes it might be best left alone, lot of work involved, that 860 will get some use that is for sure.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The River Tractor - by Charlie English Jr.. This is a 4010 John Deere that was used to farm on the Diamond Island which is in the Ohio River about 15 miles southwest of Evansville, Indiana. About ten years ago, this tractor was parked close to the bank as the river was washing the bank of the island away.
... [Read Article]
Latest Ad:
1945 Farmall wide body gas with pto and front plow. Runs good but needs new points.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
