Posted by Bob Kerr on January 29, 2008 at 22:58:59 from (64.12.117.74):
In Reply to: Re: Its decapitated posted by Andy Motteberg on January 29, 2008 at 20:08:52:
As Andy says block of wood and I cut the wood slightly tapered on one end and hit the piston at the side right next to the sleeve wall. If you hit the top it can pop a hole in it. I got one unstuck with nothing but a little splash of kero and hit one side of the piston and then the opposite side with every tap so the piston would rock in the bore a little bit. Worked like a charm! this thing was super rusted and you couldn"t tell where the piston stopped and the sleeve wall began. Had it unstuck in an hour and a half and no damage! Even reused the old cast iron pistons and sleeves. (I still can"t belive they cleaned up good enough to reuse!) If your oil pan is off you can put a piece of wood up against a crank shaft throw that is horizontal and use a jack under that to get it to move. Just tap those pistons easy, it don"t take much to losen them like I decribed.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Show Coverage: Godfrey, Illinois Country Days - by Cindy Ladage. Except for last fourth of July's Old Gold show in Springfield, Illinois, I don't remember when it was so hot. Nevertheless, the heat didn't keep vendors and visitors alike from enjoying the third annual Country Day's Event. Jane Elliott said the event was originally a one man show. "Barry Seiler, owner of Country Town Farm Supply store used to invite people up to the Johne Deere store. He would give hats and a free meal for everyone that brings a tractor." Elliott said while this
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
