What are you using 7018 electrodes with, what kind of machine and settings ?
I can see that happening with this electrode if there is not enough amps and or heat, you can only turn the power down to a certain point to where it will stick when you try to start an arc. Slag on the end of the electrode will close the circuit, for the re-strike you have to knock off the slag, so if you knock it off by tapping against the work, you can start a cycle of this happening. On lower power you need a steady hand, maintaining the arc length uniformly is important, slight change in distance it will stick or close the circuit.
This electrode likes heat, I run a Miller NT250 trailblazer, commonly using Lincoln Electric 7018 DC electrodes between 90 and 120 amps 1/8" and 5/32" and am self taught so I am no expert, but through practice I can produce a very respectable weld, with good base metal penetration, little or no porosity and a good weld profile. I did have some good knowledge of welding practice having been in the construction industry, dealing with AWS criteria and inspections, which helps. The 7018 is strong and does seem to make a good choice for equipment repairs and steel fabrication at home.
Not bad for an amateur, I modified a garage door hanger in when making repairs to an old garage door in a customers building, darned thing was improperly lag bolted to the bottom of wood roof trusses, to the bottom chord, was ready to pull out and the door would have fell on someone soon. Cleaned off the paint where the welds were to be, used the Miller NT 250 with 7018, also it's real important to have a decent clean lense in your shield, as well as having the work illuminated, that was my biggest problem, once I could see the work better, the weld profiles immediately improved.
Overkill, but practice is always good, more than 1 pass here:
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - A Brief History of Tractors in Australia - by Bob Kavanagh. After Captain Cook's exploration of the east coast in 1770 the British Government decided to establish a penal colony in Australia. The first fleet arrived in 1788 and consisted mainly of convicts who were poorly equipped and new little of farming techniques. The colony remained far from self-supporting and it was not until the early 1800's that things started to improve. Free settlers started to arrive, they followed the explorers across the mountains and where land was suitable set up farms. T
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
