Posted by James Tabor on February 06, 2008 at 11:36:46 from (206.166.230.5):
In Reply to: Re: Beware posted by Gun Guru on February 06, 2008 at 09:19:29:
No plowing. This tractor is a show tractor. It is so slick with so much attention shown to detail(Cosmetically) it is hard to believe that the engine wasn't gone through too. You can tell by looking at it that all the gaskets are new. There are absolutely no oil leaks or rust anywhere and this is four years after restoration. The engine pops like it should and didn't smoke any. It is a hand crank and usually starts on the 2nd spin. I checked for end play of the crank and it has the factory spec 1/8'. The stearing is tight and the tires are new. Every bolt is correct. It has a new radiator, manifold, guages,flawless sheet metal,magneto, Jorde decals I could go on and on. The only thing I can figure is since it did run so well that maybe it hadn't seen much use in it's life so the restorer saw no reason to rebuid the engine. Nevertheless it should not have been advertised as having been completely overhauled. The reason I notice a problem was because I flushed the cooling system and washed all of the Stop leak out of it. The leak was coming from the push rod sleeves. I spoke with a head rebuilder here who has been in business for forty years. He says he has rebuilt hundreds of these old heads and has never had to replace the sleeves. From what I can find out this is somewhat of an uncommon problem although it does happen sometimes.I did test drive it in every gear, low and high range. Put the PTO in gear. Every thing works fine. I am having the head rebuilt with new sleeves. I will probably be out an additional $300.00 plus my own labor when all is said and done. A small price to pay for a leason learned and in the end I will have a very nice B.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
