Vern-MI said: (quoted from post at 15:26:28 02/07/08) The new head is redesigned to eliminate the problem. The change took effect at the begining of the 2005 model year. The new head uses an Autolite HT plug which has plenty of thread and an extended reach. I just changed the plug and the coil on a 2005, 5.4 liter and then was notified by mail that the injectors that year were troublesome and subject to free replacement if any fail up to 10 years or 120,000 miles. I took it in and they replaced the injector free of charge. MIL code indicated left bank rich and cylinder #5 misfire. Runs like a top now.
That is a completely different head, yours is a three valve engine with variable valve timing, his 2001 is a two valve engine with the standard style OHC valvetrain. I don't think the heads are remotely interchangable.
BTW on the 04+ trucks (when they went to the 3 valve engines) the extended reach part of the plug gets corroded can break off in the cylinder head which is almost as bad as them shooting out. Too bad they can't find a happy medium, like they had for almost a 100 years before they messed it all up.
Back the the 2 valve engines, torqueing the plugs to spec is critical when you change them. It seems most of the time when this comes up, they were tightened "about that tight" which is probably either too tight or not tight enough. Too tight and you start to strip the threads outright, not tight enough and the plug works them until they give.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
