If I were you, I"d lay 1-1/4 ballast rock( no fines) down first then make a groove in them and lay the pipe in the groove and add more ballast then put the landscape cloth over that. (You want the landscape cloth to act as a filter for the dirt so you drains don"t get clogged with it.) I lived in an 80 inch rainfall area that"s how the excavating contractors handled wet spots.
I can tell you what I"m doing as I build my working corral. I have scraped off about 12-15 inches of top soil. I am planning on bringing in 12-15 inches of sand. If I had any low spots that will tend to collect water, I would dig them out about 6-8 additional inches, bring in 1-1/4 inch ballast, lay a drain pipe in a groove on that, connecting it to a lower spot so that water drains away, add more ballast, cover with landscape cloth and then cover with sand. I live in a ~16 inches of annual rain area so I think what I"m doing will work well for me. If you live in a higher annual rain fall area you may want to slope the corral toward the middle, bring in ballast, lay it down 5-8feet from the centerline and about a foot deep, groove it along the centerline and lay in your drain pipe and drain to a low spot outside of the corral, cover with more balast, then landscape cloth that sand. Your local NRCS or Conservation District should be able to provide you with recommendations. Hope this helps you.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - An Old-Time Tractor Demonstration - by Kim Pratt. Sam was born in rural Kansas in 1926. His dad was a hard-working farmer and the children worked hard everyday to help ends meet. In the rural area he grew up in, the highlight of the week was Saturday when many people took a break from their work to go to town. It was on one such Saturday in the early 1940's when Sam was 16 years old that he ended up in Dennison, Kansas to watch a demonstration of a new tractor being put on by a local dealer. It was an Allis-Chalmers tractor dealership,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
