Posted by JoshuaGA on February 10, 2008 at 18:06:16 from (74.244.197.228):
In Reply to: Frozen engine block posted by Dan-IA on February 10, 2008 at 12:03:20:
I don't know about welding. Cast parts, especially cast iron, cracks when heated in a localized spot. If you just take a rod to it, I bet the crack jist moves somewhere else. At the least, it needs to be heated everywhere surronding the crack, welded while hot, and be allowed to cool extremely slow. Dad lost a good 504 to a bad block, and IH did not supply any new 504 engines, so the tractor was traded. If it is a sleeve, just resleeve it. If it is the block, and it isn't highly pressurized, cold weld aka JB Weld may be best. Then again, if it was an M, a block or even an entire engine may be the cheapest and most economical choice, especially for a working tractor.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Oliver 550 Purchaser Checklist - by Greg Sheppard. Pound for pound the 550 is better than anything I've seen. It has great power for its size and can really hunker down and lug. Classified as a 3-bottom plow depending on soil conditions. I personally don't think it can be beat for a utility tractor in the 40 HP range. They are extremely thrifty on fuel, at least my DSL is. Most drive train parts are fairly easy to get. Sheet metal is probably the hardest thing to
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
