Posted by Dick L on March 14, 2008 at 07:32:50 from (72.11.21.66):
What ever the magneto you have on the tractor is or what it was installed on when new. If it ran this tractor before it will again, If the problem is the magneto. If you take the time to do what I am going to explain you will know if it will run again with this magneto.
With the spark plugs out of the engine, Put all four spark plugs on the plug the wires with the wires pluged into the magneto. Clamp each plug to a metal strap/bar/flat stock, or what ever you can find that is metal and then clamp it to the engine some where so that you can see the plugs spark while turning the hand crank. Inching the crank until you see a spark and you know that the engine is on the compression stroke on number one cylinder. Mark that plug and wire number one. At this point I don't care which terminal on the magneto the wire is pluged into. When you are sure you have the center line in the inspection hole when you see spark then inch the crank until you see spark on another plug. Mark that plug wire and plug number two. Then inch inch the crank until you hear the snap and see the spark and mark that plug wire and plug number four. Then inch the crank until you hear the snap and see the spark and mark that plug wire and plug number three. Continue to inch the crank until you hear the snap and see spark to double check that it sparks on the wire and plug you have marked number one and that the center line is in the center of the inspection hole.
If it is not there you will have to make an adjustment to the magneto to get the line there on number one and start over. The above is what needs to happen to make that engine to run.
If this does happen in the sequence I have detailed the engine will not run.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Box Plow Blues - by Tom Schwarz. One of the first implements most tractor owners obtain is the box plow. For very little money, this piece of equipment promises to plow and flatten any hill or vale on your ranch road or farm. At least that's what I thought! As simple as a box plow appears, it can be rather challenging to make work correctly. In our sandy soils of Florida, traction is king. You can never have wide enough tires or heavy enough weights to get all the traction you want … unless you own a monster tractor. U
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
