Posted by JT on March 23, 2008 at 13:03:28 from (70.12.221.84):
In Reply to: Lawnmower Time II posted by Lanse on March 22, 2008 at 18:23:34:
Lance, What you have there is the drive pully and the top of the PTO clutch. If you want something to juse ride on, take all that mess off, go to TSC, get a 1" pully with the same pully OD, with a set screw, put it on there and tighten the set screws and you are done. If you want to keep that piece on there and it is still tight on shaft, get a peice of pipe to fit shaft, get a 7/16 or 3/8 bolt, what ever size is there, it is one of the two, and fender washer,and put the pipe on the shaft. Now, make sure you have a fine thread bolt you are trying to insert in the shaft. If you do not have a fine thread bolt, that would explain why it will not thread in. Where is the lower part of the PTO and the lever that holds it all together? Jim
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
