Posted by Jim.UT on March 27, 2008 at 09:03:59 from (64.122.18.247):
In Reply to: release bearing posted by Gifford Sykes on March 26, 2008 at 12:16:44:
My previous reply assumed you already had the bearing hub assembly out of the tractor. I'm now wondering if you're asking how to remove the hub/bearing assembly from the input shaft.
Does your 600 have a 4 speed trans or a 5 speed? Single clutch or double clutch? My tractor is a 5 speed with single clutch. The inside of the bell housing looks like this: Yours will look similar if you have a 5 speed. It will look a little different if it's a 4 speed. In either case you need to disconnect the release bearing return spring(s). On the 5 speed, it's that coil spring around the shaft on the left of the picture. On a 4 speed there are 2 coil springs on either side of the bearing hub.
Then disconnect the clutch pedal linkage on the left side of the tractor so you can rotate the fork shaft forward until the hub can be pulled off the input shaft.
If you have a dual clutch, your input shaft assembly will look different than this, but the procedure for removing the bearing/hub assembly should be about the same.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
