Posted by Fla Farmer on March 30, 2008 at 08:43:09 from (204.49.132.156):
Hate to display my ignorance yet again - BUT need information on how to set up my disk for various purposes. Inherited an old 10 ft. disk from my dad, not drag type. Switching positions on the tiers of blades is accomplished by pulling a pin from the top of the disk and using a heavy hammer or,in my case, a heavy fence post to drive the tier to another position, either angled or straight. I want to cut my garden so that it buries the weeds, but doesn't leave big gouges in the field. THEN I want to change positions and make another pass to level the field for planting. I don't know how to set the blades to make this happen, OR how to level the disk. I do know enough to lengthen the top link so lower the front end. Advice most welcome. Thanks. (Think I'll change my sign in to "Fl. Ignoramus").
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
