I too do it freehand. As you dad did, I clamp the bar in the bench vice. (actually I have an old bar I can lay the chain on,) and I use a Dremmel tool with a grinder that is the same size as a file would be for that chain. Look at the way the chain is currently ground, and with file (or Dremmel) try to lay the file against the chain to provide the same angle(s). Once you're confident on the angle, go ahead and sharpen. You need to file until there is a sharp edge appearing on the top of the tooth. After a couple sharpenings, you may need to take the tooth off a little on the tooth that leads the cutting edge, as that controls the depth of the cut. I never had good luck with a file guide, and had one of the best (most complex) and files went dull on me in a couple sharpenings. Carefully used the Dremmel lasts quite a while, and produces results - fast!
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
