Posted by KEB1 on April 15, 2008 at 10:18:33 from (192.91.171.42):
In Reply to: 6 volt or 12 volt? posted by javan on April 14, 2008 at 18:41:19:
They were all six volt positive ground originally. If it actually has an alternator and not a generator, it's most likely been converted to 12 volt negative ground. There are six volt alternators available, but I'm not sure why someone would go to the effort of replacing the generator with an alternator & not convert to 12 volts.
There are a couple places to look for indications. First, the most telling indication is the charging system itself. Where is the voltage regulator mounted & how many wires come out of it. If there's one wire to the batter & one wire to the generator, its a cutout relay & almost certainly still six volt. If there are three terminals, its not a cutout relay and could be either 6 or 12 volt. If the regulator is mounted on top of the generator, it could be either six or 12 volt. If the regulator is mounted separately from the generator or alternator, its most likely (but not absolutely) either an alternator (12 volt negative ground) or a 12 volt generator.
Second, if a 12 volt conversion was done properly, there should be either a ballast resistor in series with the hot side of the ignition coil, or the coil itself should have been replaced with a 12 volt one. If there's no ballast and the original coil, its probably still 6 volt. If its magneto ignition, this wouldn't apply as a magneto operates indpendently of any electrical source.
Check more light bulbs. If they're all six volt, its a good bet the tractor is still six volt, unless of cours as previously pointed out they're all burned out.
One last option is to take the generator/alternator/regulator to someplace that specializes in generators & alternators & have them identify it.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
