Startup sounds normal. The pump breather tube is just a 1/8" tube around the back side of the pump and it should run down along the engine block. I believe it's attached to the pump with a banjo fitting. Just remove it and blow it out with air. Also, just remove the level plug from the pump and see if the cambox is full of fuel. That will tell you right there if that's the fuel source or not. To do a quick check on the injectors, start the tractor, warm it up a bit and then at idle open one injector at a time. Try to determine if the engine staggers about the smae amount each time. If you open one and the engine doesn't stagger, or it's less than the rest you would pull that injector and look at it. Otherwise I wouldn't pull any of them. If you do go to remove any, hope that the injectors are on bolts rather than studs... Get two big curled pry bars (injector bars) and lift evenly on each ear of the injector. If the injector is bolted in then you can give the injector a twist to break it loose. If it's on studs, you can't...
To be honest I've never seen a Simms/Minimec pump get bad pumping elements to the point that they're passing a lot of fuel. I've heard of it, but not seen it myself. I'm told the tractor will start hard when it's hot if that's the situation. The other possibility is a crack in the pump's fuel manifold or a perhaps a bad gasket, although I'm not sure about the gasket.... This is getting complicated.
One more thing that I just though of..... Pull the air intake hose off the intake manifold and look in at the thermostart unit. See if there's fuel running down the manifold. That's another culprit on those tractors. Check that FIRST. That would be an easy fix.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - An Old-Time Tractor Demonstration - by Kim Pratt. Sam was born in rural Kansas in 1926. His dad was a hard-working farmer and the children worked hard everyday to help ends meet. In the rural area he grew up in, the highlight of the week was Saturday when many people took a break from their work to go to town. It was on one such Saturday in the early 1940's when Sam was 16 years old that he ended up in Dennison, Kansas to watch a demonstration of a new tractor being put on by a local dealer. It was an Allis-Chalmers tractor dealership,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.