Posted by KEB1 on April 29, 2008 at 08:38:31 from (192.91.171.36):
In Reply to: W9 will not fire posted by David Novak on April 29, 2008 at 04:51:07:
First of all, did you take the distributor drive mechanism off the tractor? If all you took off was the distributor itself, then the drive tabs on the magneto will only fit into the shart in two positions, one of which will be right.
If the mount was removed from the tractor, the drive gears will probably be out of time. I don't remember if there are timing marks on the drive gears or not, but in any case, you can set it without them. Mount the magneto to the drive housing so that when you turn the drive gear the magneto turns.
Bring engine around so #1 cylinder is most of the way up on the compression stroke. Set magneto so that the rotor is pointing just ahead of cylinder #1 terminal, you should feel some resistance as the impluse spring starts to engage. Install magneto. Turn engine to bring #1 over compression. Impluse on magneto should trip just AFTER top dead center, and rotor should now be pointing at the other side of #1 terminal (it'll spark as the impulse brings it past the terminal).
Bring the engine around a couple more times & make sure the impluse trips slightly after top dead center. If it trips before or significantly after top dead center, you'll need to adjust the timing by one tooth one way or the other. The magneto will automatically advance the spark once the engine is turning fast enough to disengage the impulse (actually, the impulse retards the spark when its engaged)
Keith
PS..Fine adjustment is made by loosening the magneto mounting bolts and rotating the magneto housing in the slots.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
