Posted by robertmn on May 04, 2008 at 09:57:21 from (207.200.116.13):
In Reply to: What now?!?! posted by Lanse on May 04, 2008 at 08:37:09:
Lanse; I always take a ring and install it in the bore, useing the top of the piston to SQUARE the ring in the bore. Then use a feeler gauge to the gap. Then VERY carefully file the right gap. There is a fancy tool to do this with, a little wheel and a hand crank. but I put a fine file in the vise, and very carefully file the ends, then back to the bore, to ck......ck a lot........file little. DON"T quit asking how. My 16 old grandson is making a light bar for his 4x4 and I'm helping...I'm in Ca. right now and he's back in Mn. so he calls and we figure it out!! Have fun Bobmn
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
