Welll, no, or maybe, depending... The FBB's were too late for the 30 McCord (with a 30 pub date assume covered thru 29) but they do show in a later Fitzgerald, lumped in with other IH FBB's and FBC's... Fitz shows their Hd #033L for the FBB3, 279 and 298 (replaces OE #36132HA)... They show their Hd #0633C AND their #0633L for the FBB318, 361, 401 and 450 (apparently replaces OE #137810R1). Both the C and L versions are listed for all four engines. The two engines (298 and 318) must have dimensional differences as the valve grind sets, the rocker arm cover sets and the timing cover sets are different, all following the two engine sets (3-279-298 and 318-361-401-450) above. No dig cam, and catalog is a poor green on white, but send a mail adds and I'll try xeroxing the page, as some of the minor gaskets and seals seem to be the same for all the 10 engines in this segment. This is a little bare-bones catalog, no pix of the head gaskets. You can almost certainly get expert advice on what could be swapped on oldihc.com. Good luck.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
