Posted by Phil Doolittle on May 06, 2008 at 05:57:56 from (71.120.53.111):
In Reply to: battery question posted by farm M on May 05, 2008 at 19:51:31:
In Positive Ground Direct Current ( DC ) systems Regardless of voltage spark ignition systems in internal combustion engines the spark starts from the outer metal electrode, not the center electrode. The electrical erossion due to the spark eats away the steel. This is the part you adjust for the spark gap. When early spark plugs were made you could disassemble them to clean the center electrode and file it FLAT. This aided the intensity of the spark hence ignition. Further improvements in sparking plugs were to seal the porcelin to the center steel rod as well as to the threaded base. As newer harder alloys were developed the internal rod is connected to harder metals such as platinum. Certain metals carry electrical current better(lower resistence). Copper is better a conductor then steel,but is too soft and melts at a lower temp. then steel as an example. SO, the center TIP only is now the harder better conductor in preminum plugs. AND yes this allows the Polarity of the NEGATIVE ground system to start sparking at the center electrode to the outer carbon steel body. BE SURE YOU FOLLOW THE POLARITY ON THE SPARK COIL IN THE CIRCUIT: ALSO helps the intensity of the Spark. Check the 50 TIPS on this site for FORD "N" tractors for further explaination. These early discoveries were by Edison & his good friend Henry Ford.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Uncle Cecil's Super A Lives Again - by Mike Purcell. A week or so out of most of my childhood summers was often spent with my Uncle Cecil and Aunt Sissie in the small East Texas town of Maydelle on their 80 acre farm. Some of my fondest memories of these visits are those of learning to drive a tractor at the helm of Uncle Cecil’s 1948 Farmall Super A. Uncle Cecil was the second owner of this wonderful little tractor, but it was almost as though he had adopted an infant. The original owner was a man from Minnesota who bought her from a local dea
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
