Posted by Skybow on May 12, 2008 at 18:51:38 from (67.55.159.4):
I have a JD 2940 with an Allied 595 loader. The other day I noticed it was down a bit of hydralic fluid. I added nearly a gallon and it was at the full mark. Today I started the tractor to use the loader. The loader raised about 8 inches and then stopped dead. When I lower it it goes down very slowly. I shut the tractor off and looked for binding or something blocking it. It was free. Every time I tried to raise the loader arms it comes up about 8 to 12 inches and then stops. The bucket worked normally so I switched the lines from the bucket to the arms. They raised and lowered normally. Is there a bleed fitting on the control unit? Could it have an air or water lock preventing it from operating? Do I need to replace or rebuild the hydralic control unit? Any help would be appreciated.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
