|
Tractor Talk Discussion Board |
Re: Ford Loader
[ View Follow Ups ] [ Post Followup ] [ Return to Tractor Talk Discussion Board ]
Posted by Dave on January 24, 2000 at 21:01:11 from (158.252.49.33):
In Reply to: Ford Loader posted by NormZ WI on January 12, 2000 at 19:21:24:
Norm, I have a Ford Loader 19-117 which was called a 68 Standard loader. I checked out the N news letter (http://www.n-news.com/newpages/manuals.html) under archives and the model you mentioned was called an industrial loader. I'll bet this is close to what I have and here is some background. The frame itself usually contains the hydraulic fluid so cutting that cross pipe is risky. The pump mounting setup might tell you what tractor it came off of. If it's a simple looking design it probably was off a hundred series (my bet). If it looks conical in design, then an "N". I don't know Massey tractors but it appears there would be a lot of adapting. The crankshaft to pump setup has to be right on. The hardest part would be getting the distance right. The loader has a pretty good capacity but I don't have any specs. The archive list can be obtained and would give more info. The loader I have came in two models, standard (no pump) and the industrial(front pump). I completely built a hydraulic system from ground up to make this like the industrial. I went to a good cylinder Hydraulic shop and they had good advise. The pump was about $320.00, dual controls $150.00/ etc. They were able to put new seals in the cylinders. I avoided old pumps and the headaches trying to find parts if needed. Unless it looks like a simple project and your welding skills are good, dive in. This topic crops up from time to time in the ford forums and implements forum. Good luck!
Dave
Follow Ups:
Home
| Forums
Today's Featured Article -
Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
18-32 Case Cross Motor
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
