Posted by russell1976 on May 14, 2008 at 06:53:26 from (158.106.52.10):
In Reply to: jd500 swing cylinder posted by russell1976 on May 06, 2008 at 19:29:33:
So after parking the machine, I found there to be a pinhole in the fuel tank, and a steering hose started leaking on my way back to the garage. So I removed the fuel tank, and welded it up, and replaced the steering hose. I have also rebuilt one of the steering cylinders as well due to a leak. All things are going smoothly BUT. Now i have started to remove the rotary boom swing cylinder, and have run into a few snags. After supporting the boom, and removing the lower pin and the lift cylinder pin, i cannot get the lower bearing hat off of the frame. The upper one came off, and i removed the coupler, but the lower cap will not budge. I am assuming that when it comes off, that i can take the barrel out rotary cylinder out at that point for rebuild? i think?? Any suggestions???
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - George's Fordson Major - by Anthony West (UK). This is a bit of a technical info to add on to the article about George's Major in the "A Towny Goes Plowing" article. George bought his Major from a an implement sale about 18 years ago for £200.00. There is no known history regarding its origins or what service it had done, but the following work was undertaken by Harold alone to bring it up to show standard. From the engine number, it was found that the major was produced late 19
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
