Posted by Dan-IA on May 20, 2008 at 19:44:39 from (66.43.223.97):
In Reply to: Well Pump posted by Sam Mansell on May 20, 2008 at 18:22:21:
Are you sure you got it primed okay? Seriously, those pumps are a b*tch to get primed! (I've wasted many long sleepless nights trying to prime those pumps!)
Remember it takes only a tiny little air leak and it will lose its prime. Best method I've found to prime those pumps is to fill the pressure tank with water and cycle the pump repeatedly (say, 40 times or so.) You can tell by the sound when it's pumping air instead of water, so shut it off then. In most cases the pump will be at the highest point in the plumbing for the well, so the air bubbles will find the pump and lose the prime. This is when shutting the pump off allows water to back-flush from the pressure tank, re-priming the pump. When the water quits "wooshing", turn the pump on again. Repeat until it works. (If you fill the pressure tank first and have everything else all plumbed up, then cycling the pump is just a matter of pulling up on the flat lever near the bottom of the pressure switch.)
How far is the well from the pump? It's amazing how much water that piping will hold!
You had the pump off the source lines. Black plastic? I could never get a perfect seal again on that pipe, I had to shorten it by about 2-3 inches (how far the nipple stuck into the pipe.) Even 3 hoseclamps won't squeeze it tight enough.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
