Posted by RAB on May 21, 2008 at 15:23:46 from (205.188.117.74):
In Reply to: no Spark to Plugs posted by Jim Bevins on May 21, 2008 at 04:14:56:
Jim,
As I read your post, it appears there is absolutely nothing wrong with your ignition spark, production-wise. The problem is in the distribution to the plugs - ie the distributor.
I am presuming you had a fat blue spark when it actually quit? You are referring to the high tension spark? The one from the coil centre plug-lead type wire. That means your points etc and coil are OK. If you did not check for spark when it actually quit there could be these other issues, but if there was a high tension spark it must be one of these two components - cap or rotor.
There may be an issue with ballast resistor etc but if the spark was there, up to the distributor cap, they are a side issue.
If you are referring to low tension electricity as 'spark to the distributor', disregard the above and start checking from the basics.
So, IF you have a good high tension spark going into the distributor it must be getting 'lost' in the distributor cap or rotor. There are no other parts in this section, unless all the spark plug leads and plugs have failed all at the same time!!
While I can understand that some posters are not real good at describing the symptoms and exactly how/when things were checked, we can only comment/reply on the information you have given. It is a shame that some replies are laying red herrings along the way, so if you think your initial post was not accurate, update it with more information. We want you to find the fault and fix it.
I would initially go with a shorting rotor as my first guess as you are likely to see tracking lines or cracks in the distributor cap.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
