Posted by mowr on May 26, 2008 at 19:06:47 from (67.96.1.76):
In Reply to: M-M 445 posted by dan field on May 26, 2008 at 15:40:15:
I"m guessing that it has the same general arrangement as the M-M 335. My 335 book shows the reservoir and filter cannister assembly under the seat. Capacity 6 qts. with power steering, 5 1/2 qts. without P/S (the capacity will be correspondingly more, of course, if a loader and/or other cylinders are in the circuit. Instructions: Clean thoroughly around plate before removing plate to check fluid. Make sure lift arms are all the way down and any other cylinders (loader, etc) supplied by the tractor hydraulics are retracted. Fill with automatic transmission fluid Type A (or current equivalent) to within 1/2 inch of the top of the reservoir. Change fluid and filter cartridge every 1000 hrs. Clean cannister and screen thoroughly before installing new cartridge. Reservoir drain plug is on the right side of the reservoir, near the lower rear corner. If your 445 isn"t exactly the same, I hope this at least gets you in the ballpark. Good luck.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
